TinySA Ultra 100KHz-5.3GHz 4 inch Display Hand Held Small Spectrum Analyzer RF Generator with Battery
- Without marking: Maximum 10 - 15 business days
- Fast delivery: Maximum 10 business days
- 5-Day Delivery: Maximum 5 business days in the EU
- We deliver to the following countries: All countries in the European Union, UK, USA, Canada. If you do not fall within these countries, you can check the checkout section to see if we deliver to your country.
- Spectrum Analyzers
Characteristics:
-Screen size 4 inches
-Spectrum Analyzer for 0.1-800MHz or, with Ultra mode enabled, 0.1MHz-6GHz
-Signal generator with sine wave output between 0.1-800MHz or square wave or dual tone output up to 4.4 GHz when not used as a spectrum analyzer.
-Switchable resolution bandpass filters for both bands between 200Hz and 850kHz
-Optional built-in 20dB LNA
-Color display showing 450 scanning points covering up to the full frequency range.
-Input Step attenuator from 0dB to 31dB (not in combination with LNA).
-A built-in calibration signal generator that is used for automatic self-test and input (low) calibration.
-Connected to a PC via USB, it becomes a PC controlled Spectrum Analyzer or Signal Generator
-Rechargeable battery allowing a minimum of at least 2 hours of portable use
Maximum input level + 10dBm. Don't destroy your tinySA
-Due to the low cost and very small form factor, there are certain relevant tinySA limitations and tinySA Ultra limitations
tinySA ULTRA includes:
Host (with 3000mAh battery, 4" display) x 1
USB Type-C data cable x1
Cables x2 ALSR100 SMA 30cm
SMA-SMA barrel connector x1
Antenna with SMA x1 connector
String and pick x1
32GB MicroSD card (connected to host) x1