Characteristics:

-Screen size 4 inches

-Spectrum Analyzer for 0.1-800MHz or, with Ultra mode enabled, 0.1MHz-6GHz

-Signal generator with sine wave output between 0.1-800MHz or square wave or dual tone output up to 4.4 GHz when not used as a spectrum analyzer.

-Switchable resolution bandpass filters for both bands between 200Hz and 850kHz

-Optional built-in 20dB LNA

-Color display showing 450 scanning points covering up to the full frequency range.

-Input Step attenuator from 0dB to 31dB (not in combination with LNA).

-A built-in calibration signal generator that is used for automatic self-test and input (low) calibration.

-Connected to a PC via USB, it becomes a PC controlled Spectrum Analyzer or Signal Generator

-Rechargeable battery allowing a minimum of at least 2 hours of portable use

Maximum input level + 10dBm. Don't destroy your tinySA

-Due to the low cost and very small form factor, there are certain relevant tinySA limitations and tinySA Ultra limitations

tinySA ULTRA includes:

Host (with 3000mAh battery, 4" display) x 1

USB Type-C data cable x1

Cables x2 ALSR100 SMA 30cm

SMA-SMA barrel connector x1

Antenna with SMA x1 connector

String and pick x1

32GB MicroSD card (connected to host) x1