BT-200 Bias-Tee Low Noise Amplifier 0.5–5GHz LNA for bladeRF SDR RX Ports
Acestea sunt câteva dintre metodele de livrare pe care le folosim. Totuși, disponibilitatea și timpul de livrare pot varia în funcție de țara dvs.
- Protecția comenzii: Dacă comanda ta se pierde, îți garantăm un înlocuitor sau o rambursare. Se aplică termeni și condiții.
- Retururi ușoare: Bucură-te de un proces de retur simplu și fără bătăi de cap.
- Plăți flexibile: Alege dintre mai multe opțiuni de plată sigure, potrivite nevoilor tale.
- Prețuri avantajoase: Obține cea mai bună valoare pentru toate produsele noastre.
The BT-200 Bias-Tee Low Noise Amplifier is a wideband RX LNA designed specifically for bladeRF SDR platforms, providing a simple way to dramatically lower system noise figure and increase receive sensitivity. Featuring a Mini-Circuits TSS-53LNB+ MMIC, the BT-200 delivers ultra low noise performance from 0.5GHz to 5GHz, making it ideal for weak-signal work, satellite, GNSS, ISM, LTE, and general RF experimentation.
Powered directly through the bladeRF’s RF SMA connectors via integrated bias-tee circuitry, the BT-200 requires no external DC cabling. Power is fully software-controllable via de>bladeRF-cli or any application using de>libbladeRF. A green LED clearly indicates when the LNA is enabled, and when the port is unpowered the amplifier automatically enters bypass mode with about 4dB insertion loss, protecting your receive chain and keeping things predictable.
Key Features
- Frequency range: 0.5GHz – 5GHz wideband low-noise amplifier
- MMIC: Mini-Circuits TSS-53LNB+ ultra low noise MMIC
- Typical gain: ≈ +20.2dB @ 200MHz, ≈ +16dB @ 2.4GHz
- Noise figure: Ultra low NF for significantly improved receiver performance
- Power consumption: ~300mW via bias-tee from bladeRF RX port
- Indicator: Green LED shows when the LNA is powered
- Bypass mode: LNA enters bypass (~4dB IL) when bias-tee power is off
- Compliance: NDAA compliant design
Compatibility
- SDR devices: Compatible with bladeRF xA5, bladeRF xA9, bladeRF xA4, and bladeRF 2.0 micro RX ports
- Accessories: Works with the Micro Enclosure and external DC power supply (recommended when using multiple bias-tee modules)
Control & Usage
- Enable LNA via CLI: de>set biastee rx on
- Disable LNA via CLI: de>set biastee rx off
- Check power budget: de>print hardware in de>bladeRF-cli
- GNU Radio: add de>biastee=rx to de>gr-osmosdr source blocks to switch the LNA on from within flowgraphs
Because the BT-200 draws its current from the bladeRF’s bias-tee supply, care should be taken when powering the SDR solely from USB, especially when multiple BT-series modules are attached. For higher power budgets and maximum linear performance, using an external DC supply with the bladeRF is recommended. Note that the BT-200 is intended for RX ports only.
Kit Contents
- 1 × BT-200 Bias-Tee Low Noise Amplifier
The BT-200 is a compact, plug-and-play LNA solution for bladeRF users who want to substantially boost receive sensitivity and dynamic range without adding complex external biasing hardware.
No questions yet
Nu au fost găsite recenzii
